58S5560-30F-EIFigure 66 S5560-30F-EI front panel(1) SFP port (2) SFP port LED(3) 10/100/1000BASE-T autosensing Ethernet port (4) 10/100/1000BASE-T autosensing Ethernet port LED(5) Management Ethernet port (6) Console port (CONSOLE)(7) Mini USB console port (8) Port LED mode switching button(9) USB port (10) System status LED (SYS)(11) SFP+ port (12) LED for the port LED mode (MODE)(13) Expansion card status LED (SLOT) (14) Power module 2 status LED (PWR2)(15) Power module 1 status LED (PWR1) (16) SFP+ port LED(17) Management Ethernet port LEDFigure 67 S5560-30F-EI rear panel(1) Grounding screw (2) Expansion card(3) Fan tray 1 (4) Fan tray 2(5) Power module 1 (6) Power module 2The S5560-30F-EI switch comes with power module slot 1 empty and power module slot 2 installed witha filler panel. You can install one or two power modules for the switch as required. In this figure, twoPSR150-A1 AC power modules are installed in the power module slots. For more information aboutinstalling and removing a power module, see "Installing/removing a power module."The S5560-30F-EI switch comes with the two fan tray slots empty. You must install two fan trays of thesame model for the switch. In this figure, two LSPM1FANSA fan trays are installed in the fan tray slots. Formore information about installing and removing a fan tray, see "Installing/removing a fan tray."The S5560-30F-EI switch comes with a filler panel in the expansion slot. You can select an expansioncard for the switch as required. In this figure, an LSWM2QP2P interface card is installed in the expansionslot. For more information about installing and removing an expansion card, see "Installing/removing anexpansion card."1 2 3 4 5 6
