H3C S5820X-28S Installation Manual

Also see for S5820X-28C: Command reference Installation manual Manual

5-133) Run the terminal emulation program on the PC connected with the switch’s console port. Start theswitch and enter the Boot ROM menu. Then enter the protocol parameter setting menu.If you want to load the Boot ROM file, enter 6 in the Boot ROM menu after the system displays “Enteryour choice(0-9):” to enter the Boot ROM update menu.1. Update full BootRom2. Update extended BootRom3. Update basic BootRom0. Return to boot menuEnter your choice(0-3):4) Enter the protocol parameter setting menuEnter 1 to update the complete Boot ROM file, and then enter the protocol parameter setting menu.Bootrom update menu:1. Set TFTP protocol parameter2. Set FTP protocol parameter3. Set XMODEM protocol parameter0. Return to boot menuEnter your choice(0-3):5) Configure the switch to upload the Boot ROM file through TFTPEnter 1 to update the Boot ROM file using TFTP, and then set the TFTP parameters.Load File Name :update.binServer IP Address :10.10.10.2Local IP Address :10.10.10.3Gateway IP Address :The parameters are described in Table 5-5.Table 5-5 Description of the TFTP parametersItem DescriptionLoad File Name : Name of the file to be downloaded (for example, update.bin)Server IP Address : IP address of server (for example, 10.10.10.2)Local IP Address : IP address of the switch (for example, 10.10.10.3)Gateway IP Address : IP address of the gateway (suppose it is not specified)z Enter the file name and IP addresses based on the actual condition.z If the switch and the server are on the same network segment, you can specify any unused IPaddress of the network for the switch without specifying the gateway’s IP address; if they are not onthe same segment, you need to specify the gateway’s IP address so that the switch cancommunicate with the server.