5-19The current boot app is: flash:/update.binThe main boot app is: flash:/update.binThe backup boot app is: flash:/update.bin rebootz After loading the application file, use the reboot command to restart the switch to make the updatetake effect (make sure you have saved other configurations before restart).z If the flash memory does not have enough space, you can load the Boot ROM file first, and thendelete certain application files from the flash memory (you are recommended to delete the unusedhost program files); then, load the application file to the switch through FTP for update.z Avoid any power failure during the loading process.Loading Software Using FTPAs shown in Figure 5-9, run FTP Server on the local host, configure username admin and the password,and specify the path of the file to be downloaded (suppose the IP address of the FTP server is202.10.10.53). Then, telnet to the switch and send the host program file to the switch using FTP.Figure 5-9 Load software through FTPSuppose the Boot ROM and application files are stored in the file named update.bin, follow these stepsafter you telnet to the switch.Step1 Download the file to the switch using FTP. ftp 202.10.10.53Trying ...Press CTRL+K to abortConnected.220 WFTPD 2.0 service (by Texas Imperial Software) ready for new userUser(none):admin331 Give me your password, pleasePassword:230 Logged in successfully[ftp] get update.bin update.bin[ftp] byeStep2 Upgrade the Boot ROM program. bootrom update file update.bin slot 1This command will update bootrom file on the specified board(s), Continue? [Y/
