H3C S7500E Series Command Reference Manual

Also see for H3C S7500E Series: Installation manual Operation manual Command manual Installation manual Configuration guide

H3C S7500E Series Command Reference Manual Manual pdf 169 page image

7-17 MAC Address Table Configuration Commandsz Currently, MAC address table configuration applies to Layer 2 Ethernet port, and Layer 2aggregate interfaces only.z This document covers only the configuration of static, dynamic, and blackhole unicast MACaddress table entries. For more information about the configuration of static multicast MACaddress table entries, see Multicast Routing and Forwarding Configuration and IPv6 MulticastRouting and Forwarding Configuration in the IP Multicast Configuration Guide.MAC Address Table Configuration Commandsdisplay mac-addressSyntaxdisplay mac-address [ mac-address [ vlan vlan-id ] | [ [ dynamic | static ] [ interface interface-typeinterface-number ] | blackhole ] [ vlan vlan-id ] [ count ] ] [ | { begin | exclude | include }regular-expression ]ViewAny viewDefault Level1: Monitor levelParametersblackhole: Destination blackhole MAC address entries. These entries do not age but you can add orremove them. Packets whose destination MAC addresses match destination blackhole MAC addressentries are dropped.vlan vlan-id: Displays MAC address entries of the specified VLAN, where vlan-id is in the range 1 to4094.count: Displays the number of MAC address entries specified by related parameters in the command.When this keyword is used, the command displays only the number of specified MAC address entries,rather than related information about these MAC address entries.mac-address: Displays MAC address entries in a specified MAC address, in the format of H-H-H.dynamic: Displays dynamic MAC address entries. Aging time is set for these entries.static: Displays static MAC address entries. Similar to blackhole MAC address entries, these entriesdo not age but you can add or remove them.