1-20If you provide no argument or keyword, this command displays all storm control settings on all stormcontrol-enabled interfaces.Examples# Display the storm control settings on all storm control-enabled ports. display storm-constrainAbbreviation: BC - broadcast; MC - multicast; UC - unicastFlow Statistic Interval: 5(second)PortName Type LowerLimit UpperLimit CtrMode Status Trap Log SwiNum Unit------------------------------------------------------------------------------GE2/0/1 BC 11 1111 N/A normal on on 0 ppsTable 1-10 display storm-constrain command output descriptionField DescriptionFlow Statistic Interval The traffic polling interval of the storm control module.PortName Abbreviated port nameType Type of traffic subjected to storm control. Options include broadcast, multicastand unknown unicast.LowerLimit Lower storm control threshold, in pps, kbps, or percentage.UpperLimit Upper storm control threshold, in pps, kbps, or percentage.CtrModeProtective action taken on the port when the upper threshold is reached,which can be block or shutdown. If you have not configured any protectiveaction, N/A is displayed.StatusPacket forwarding status, which may be one of the following:z normal – The port is forwarding traffic normally.z control – The port is in controlled mode (the actual mode depends on theCtrmode setting, which may be block or shutdown).TrapStatus of the storm control threshold event trap switch:z on – The port sends threshold event traps.z off – The port does not send threshold event traps.LogStatus of the storm control threshold event log switch:z on – The port sends threshold event log messages.z off – The port does not send threshold event log messages.SwinumNumber of times the forwarding state of the interface changes.When the Swi-num count reaches 65,535, it resets automatically.duplexSyntaxduplex { auto | full | half }undo duplex
