17-9Examples# Set the GARP Join timer to 25 centiseconds, assuming that both the Hold timer and the Leave timerare using the default. system-view[Sysname] interface GigabitEthernet 2/0/1[Sysname-GigabitEthernet2/0/1] garp timer join 25garp timer leaveSyntaxgarp timer leave timer-valueundo garp timer leaveViewEthernet interface view, Layer-2 aggregate interface view, port group viewDefault Level2: System levelParameterstimer-value: Leave timer setting (in centiseconds), which must be a multiple of 5 between two times theJoin timer (exclusive) and the LeaveAll timer setting (exclusive).DescriptionUse the garp timer leave command to set the GARP Leave timer for an Ethernet port, Layer-2aggregate interface, or all ports in a port group.Use the undo garp timer leave command to restore the default of the GARP Leave timer. This mayfail if the default is beyond the valid value range for the Leave timer.By default, the Leave timer is set to 60 centiseconds.Related commands: display garp timer, garp timer join, and garp timer leaveall.Examples# Set the GARP Leave timer to 100 centiseconds, assuming that both the Join timer and the LeaveAlltimer are using the default. system-view[Sysname] interface GigabitEthernet 2/0/1[Sysname-GigabitEthernet2/0/1] garp timer leave 100garp timer leaveallSyntaxgarp timer leaveall timer-valueundo garp timer leaveallViewSystem viewDefault Level2: System level