157Parametersgroup-id: Number of a remote source group, in the range of 1 to 4. The mirroring group specified bygroup-id must already exist.monitor-egress-port: Port to be configured as the egress port. It takes the form of interface-typeinterface-number, where interface-type specifies the port type and interface-number specifies the portnumber.Usage guidelinesYou can configure an egress port for a remote source group only, not for other types of mirroring groups.Examples# Create remote source group 1, and configure port GigabitEthernet 2/0/1 as its egress port in systemview. system-view[Sysname] mirroring-group 1 remote-source[Sysname] mirroring-group 1 monitor-egress gigabitethernet 2/0/1# Create remote source group 2, and configure port GigabitEthernet 2/0/2 as its egress port ininterface view. system-view[Sysname] mirroring-group 2 remote-source[Sysname] interface gigabitethernet 2/0/2[Sysname-GigabitEthernet2/0/2] mirroring-group 2 monitor-egressRelated commandsmirroring-groupmirroring-group monitor-portUse mirroring-group monitor-port to configure a port for a local or remote destination group as themonitor port.Use undo mirroring-group monitor-port to remove the monitor port from the local or remote destinationgroup.Syntaxmirroring-group group-id monitor-port monitor-port-idundo mirroring-group group-id monitor-port monitor-port-idDefaultNo monitor port is configured for a mirroring group.ViewsSystem viewDefault command level2: System levelParametersgroup-id: Number of a local or remote destination group, in the range of 1 to 4. The mirroring groupspecified by group-id must already exist.
