HAAS + SOHN HSP 2.17 Installation And Operating Instructions Manual
Also see for HSP 2.17: Equipment sheet
                               | |
Contents
| 
4 The pellet stove may not be installed in the openair! Attention! The mains cable plug must remain freelyaccessible after installation. The pellet stove may only be operated with standardwood pellets (6 mm diameter). (See Section 7.1“Fuel”). The protective grille located in the pellet containermust not be removed. Attention! The Pelletto stove may only beoperated with the tank cover closed. Placing non-heat-resistant materials or objects onthe stove or within the specified minimum distancesis forbidden. Here please note in particular thatduring “Standby” operating status, the stove mayunexpectedly and unintentionally start heating whenthe room temperature falls below the desiredtemperature. Never use liquid fuels to ignite the pellet stove or torevive existing embers. With the burning up of fuels, heat energy isreleased, leading to strong heating of the heatingdevice’s surfaces (e.g. doors, door and controlhandles, viewing window panels, side walls, frontwall, flue tubes). Touching these parts withoutsuitable heat protection gloves or a tool is to beavoided! The device ignites by itself in “Standby” mode.Because of the heat generated on the panel, makesure that no-one who is unfamiliar with the operationof the pellet stove is unsupervised in the room whereit is installed. Bring these risks to your children’s and guestsattention! In particular, any cleaning staff should be informedand instructed regarding the possible unexpectedheating up of the stove. Placing non-heat-resistant objects on or near theheating device (even when it is cold, since it canignite again by itself) is forbidden! Do not lay any laundry on the stove to dry! Clotheshorses for drying clothes and the like mustbe positioned at sufficient distance from the heatingdevice – fire risk! When operating your heating device, it is forbiddento work with highly flammable or explosivesubstances in the same room or an adjacent one!3. Installation of the pellet stove and connection tothe chimneyThe packaging on your new pellet stove gives it optimumprotection against damage. Nevertheless, damage mayhave occurred to the stove or to accessories in transit.Please therefore check your stove after unpacking fordamage and completeness! Report any defects oranything missing to your specialist stove dealer withoutdelay!The packaging on your stove is by and largeenvironmentally neutral. The timber packaging is notuntreated. The timber, the cardboard and the films canbe taken without problems to your local recycling centre.For the correct operation of your pellet stove it isimportant that it stands horizontally.The room temperature sensor that is located on the backwall has a length of about 1.5 m and should bepositioned hanging free at the back.Figure 1: Back connections1 = Mains electricity socket2 = OC overheat cutout3 = Room temperature sensor4 = Fume elbow 80 mm5 = Outside air connection 40 mm6 = Bottom of back wall613524 |
Related manuals for HAAS + SOHN HSP 2.17
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine