HAI SECURITY SYSTEM Owner's Manual

Also see for 21A00-1 OmniLT: Owner's manual

Contents

HAI SECURITY SYSTEM Owner's Manual Manual pdf 49 page image

SETUPThe Setup menu is used to configure operating parameters, program your system to do its automated control and securityfunctions, and give descriptions (names) for all of your zones, units, buttons, codes, temperatures, and messages. To enter theSetup menu, from the top-level display or from the main menu, press the 9 (SETUP) key on the console keypad.Upon entry to the Setup mode, you will first be prompted to enter a security code:SET UPENTER CODE:A Master or Installer Code is required to enter the Setup mode.SET UP1=CODES 2=TIME 3=PROG ↓4=DIAL 5=ARM 6=MISC7=NAMES 8=VOICE ↑Set Up CodesThere are 8 user codes that you may assign to users of the system. All OmniLT security codes are 4 digits in length (0001 to9999). Each user should be assigned a security code with an authority level, and times in which the code will be valid. To set upa code, from the Setup menu, press the 1 (CODES) key. Use the arrow keys to scroll through the codes.User Code 1 is always set to a Master code. The existing code number is not shown on the display. To change the code, enter afour digit number, then press the ' # ' key. Enter 0000 to disable the code.Remember the code number. It will not be redisplayed.CODE X:0000-9999 0000=DISABLEPress the (↓) key. You will then be prompted for an authority level for that code:CODE X AUTHORITY: 31=MSTR 2=MGR 3=USER ¦1 = MasterMaster codes have complete access to the entire system.2 = ManagerManager codes can arm and disarm the security system during assigned times. Managers can access the Main Menu if the systemis in High Security Mode, and have telephone access privilege.3 = UserUser codes can only be used to arm and disarm the security system during assigned times. Telephone access is not a Userprivilege.You can specify the access (on/off) times for the code, this is, the time periods during which the code is valid.CODE X ON TIME:8:00 AM MTWTF-- #=CHNG¦CODE X OFF TIME5:00 PM MTWTF-- #=CHNG¦45