HAI SECURITY SYSTEM Owner's Manual

Also see for 21A00-1 OmniLT: Owner's manual

Contents

HAI SECURITY SYSTEM Owner's Manual Manual pdf 7 page image

6- UP ARROWThe Up Arrow key is used to scroll through menus and lists. The Up Arrow is used to scroll back through a list (for example, ifyou have already used the down arrow to scroll to an item, the Up Arrow will bring you back to a previous item).7- CONSOLE LEDThe Console LED is used to indicate whether the security system is currently armed or disarmed. If armed in any of the securitymodes, the LED will be set to red. If the system is disarmed, the LED will be set to green. The LED will flash when a Messageis displayed.8- CONSOLE DISPLAYThe Console Display is used to show the current security mode and to give useful information that will guide you through normaloperations of your OmniLT control and security system.9- CONSOLE KEYPADThe Console Keypad is used to enter user codes for arming, disarming, bypassing, and restoring zones. In some cases, the keys(0-9) are assigned to different functions. From the top-level display, each key functions as a menu choice.10- CONSOLE BEEPERThe Console Beeper is used to confirm a keystroke, alert user of errors and troubles, and sound upon entry and exit delays.11- ' * ' KEYThe ' * ' Key is used to cancel and return the display to the previous menu. When you are entering a number, ' * ' will cancel thepreviously entered digits and will prompt you to reenter the number.12- ' # ' KEYThe ' # ' Key is used to enter or confirm a selection. It may also be used to display a menu or to offer you additional choices.Normal Top-Level DisplayIn its normal state, the console display will show the day, date, and time on the top line, and the system status on the bottom line.If all doors, windows, sensors, etc. are closed, no zones are bypassed, and if there are no troubles, the bottom line will show"SYSTEM OK" as seen below:Mon Feb 20, 06 4:00 PMSYSTEM OKIf one of the doors, windows, motion, or other detector connected to the OmniLT is open, or has detected motion, the bottom lineof the display will say, "ZONE NAME NOT RDY".For example, the display will say, "FRONT DOOR NOT RDY".If the zone name has not been entered during set up, the display will give the zone number and zone type. This display willremain for 2 seconds, then the next zone not ready, in trouble, or bypassed will be displayed.Display MenusThe system has been designed to be easy to operate. Whenever you press a key on the console, the top line of the display willindicate what you are doing. To the right of that is your selection or current setting. The bottom line will show a menu of yournext options. To the lower right corner of the display is the direction arrow(s). Where possible, the up (↑), down (↓), and two-headed (¦) arrow characters are shown on the console display to indicate which arrow keys may be pressed at that time.3