13IntroductionREAR PANEL POWERDC IN jackConnect the AC adaptor AD3-1250-2P to this jack.Use with strain relief to avoid accidentally disconnecting thepower during performance. (P. 16)POWER switchTurns the power to the SKX “ON” or “OFF.” (P. 22) AUDIO OUTPUT TERMINALSPHONES jackConnect a set of stereo headphones to this jack.NOTE: Connecting Headphones does NOT mute the LINE OUT orLESLIE audio outputs.LINE OUT L/MONO jackLINE OUT R jackUse these jacks to connect an external audio equipment.If the connected mixer or monitor speaker is stereophonic,connect both L and R. If monaural, connect only to the L/MONO jack (P. 16) and set the Audio Mode at “MONO” (P. 102).LESLIE 11 PIN socketConnect a Leslie Speaker equipped with an 11-pin interfacehere.When the connection of a physical Leslie Speaker is detect-ed, the on-board digital Leslie Simulator is disabled at thePHONES jack and the LINE OUT jacks. (P. 17) CONTROLLER TERMINALSDAMPER PEDAL jackConnect an optional Damper Pedal (optional VFP1 etc.) here.If you press the connected Damper Pedal while holding downkeys, the sound is sustained even after you release the key(s)similar to the damper pedal on an acoustic piano. (P. 78)NOTE: Use ONLY a Damper Pedal equipped with a Monaural con-necting plug. DO NOT use a pedal having a Stereo or “TRS-compatible” plug, as it will not function.FOOT SWITCH jackConnect the Foot Switch here.Please see (P. 76) for information about the different functionsavailable for the Foot Switch.Th e following Foot Switches / Damper Pedals can be used withSKX:HAMMOND VFP1, FS-9HBOSS FS-5UYAMAHA FC4A, FC5EXP. PEDAL jackConnect an optional Expression Pedal here.Th is allows you to control the volume while playing. (P. 77)Th e following Expression/Volume Pedals can be used with theSKX:HAMMOND EXP-50J, EXP-20, V-20H, V-20R; NORMKORG XVP-10, XVP-20; REVRoland EV-5; NORMYAMAHA FC7; REV MIDI TERMINALSMIDI OUT jackMIDI data is transmitted from this jack. (P. 104)MIDI IN jackMIDI data is received via this jack.NOTE: The SKX is factory-programmed to receive incoming MIDIdata from a connected MIDI Pedalboard regardless of the cur-rent MIDI Channel setting. (P. 104) USB TERMINALUSB FLASH DRIVE portUse this port to connect a USB Flash drive. (P. 116)11 PIN
