5 - Operation63VACnMIX Rinsing÷ NOTE! It is important to suck from the rising tank or an external tank with clean water.Rinse the VACnMIX and chemical containers as follows:Cleaning empty containers - VACnMIX lid open€ DANGER! Do not press the nozzle unless it is covered by acontainer to avoid spray liquid hitting the operator.1. Rotate the nozzle 90 degree to unlock1. Put container over the flushing nozzle so that the nozzle isinside the container and press bottom against the nozzle, thiswill force a powerful jet of water up into the inside of thecontainer.÷ Note: This lock acts as a safety measure to prevent injury tooperator. Ensure lock is repositioned correctly after use.VACnMIX rinsing - VACnMIX lid is closed1. Close VACnMIX lid.2. Turn the suction SmartValve towards “Rinsing tank” or “ExternalFilling Device”, if clean water is available here.3. Turn the Vacuum and Transfer Valve to FILL position.4. Flush the hopper using the rinse valve. Control the rinse byturning flush ring handle on VACnMIX control manifold to theON / OFF position.5. Rinse the hopper for 30-40 second or more if needed.6. Turn the Vacuum and Transfer Valve to EMPTY position, let valvebe open for at least 20 seconds, after the rinse water is no longervisible in the hopper, in order to completely empty the transferhoses into the main tank.μ ATTENTION! The VACnMIX needs to be cleaned thoroughlyafter finishing spraying. This is to ensure that it is clean, beforespraying other crops that may be sensitive to the chemicalsjust used. See section “Cleaning” on page 71 for details.
