5 - Operation66μ ATTENTION! If not flushed with clean water, the hopper rinsing device uses spray liquid for rinsing the hopper!Cleaning the TurboFiller must always be done, when the spray job is ended, and together with cleaning the entiresprayer. A cleaning after the last filling, and before spraying, does not ensure a clean TurboFiller!8. Close TurboFiller suction valve, when the hopper has been rinsed. Close the lid.9. If closed, turn the AgitationValve towards “Agitation”.10. When the spray liquid is well agitated, turn handle of thepressure SmartValve towards “Spraying” position. Keep PTOengaged, so that the spray liquid is continuously agitated, untilit has been sprayed on the crop.Agitation before Resuming a Spray JobIf a spray job has been interrupted for a while, severe sedimentation may occur depending on the chemicals being used.Before resuming the spray job, it might be necessary to agitate sediment material.1. Turn the handle at the suction valve towards “Suction frommain tank”. Turn the pressure alve towards “Pressure Hopper”and turn the Agitation valve towards “Agitation”. Other valvesclosed.2. Engage the pump and set PTO speed to 540 rpm or 1000 rpm(depending on pump model).3. Agitation has started and should be continued for at least 10minutes.4. The spray job can now be resumed. Turn pressure SmartValvetowards “Spraying” and start spraying.€ DANGER! Before turning Pressure SmartValve to “PressureHopper” it is very important to be sure that the quick coupler lid is correct and completely mounted to the filling studinto its locked position. Failure to do so may cause risk of contamination and injury from quick coupler lid being “shot”off when pressurized! If not possible to mount lid completely, lubricate the rubber seal and the grip hooks.
