Harman Kardon AVR 8000 Owner's Manual

Also see for AVR 8000: Brochure & specs Specifications Service manual Service manual

43 PROGRAMMING THE REMOTEProgramming the RemoteReassigning Device ControlSelectorsAlthough each Input Selector e is normallyassigned to the category of product shown onthe remote, it is possible to reassign one ofthese buttons to operate a second device ofanother type. For example, if you have two VCRsbut no satellite receiver, you may program the“SAT” button to operate a second VCR. Beforefollowing the normal programming steps foreither Three-Digit entry or Auto Search codeentry, you must first reassign the button with thefollowing steps:1. Press the Input Selector e you wish toreassign and the Mute Button at thesame time until the red light appears underthe Input Selector e and the Program/SPL Indicator c flashes amber.2. Press the Input Selector e matchingthe device type you wish to program intothe reassigned button.3. Enter the three-digit code for the specificmodel you wish the reassigned button tooperate.4. Press the same Input Selector e pressedin Step 1 once again to store the selection.The red LED under the re-assigned InputSelector will flash three times and thengo out.Example: To use the CBL/SAT button tooperate a second VCR, first press theCBL/SAT Input Selector e and theMute Button at the same time untilthe red light glows under the CBL/SAT InputSelector e button. Press the VCR Buttone, followed by the three-digit code for thespecific model you wish to control. Finally,press the CBL/SAT Button e again.Resetting the Remote MemoryAs you add components to your home theatersystem, occasionally you may wish to totallyreprogram the remote control without the confu-sion of any commands, macros or ”Punch-Through“ programming that you may havedone. To do this, it is possible to reset theremote to the original factory defaults andcommand codes by following these steps.Note, however, that once the remote is reset,all commands or codes that you have enteredwill be erased and will need to be re-entered:1. Press any of the Input Selector Buttonse and the O Button r at the sametime until the Program/SPL Indicator cbegins to flash amber.2. Press the 3 Button r three times.3. The red LED under the Input Selector ewill go out and the Program/SPL Indicatorc will stop flashing and turn green.4. The Program/SPL Indicator c will remaingreen until the remote is reset. Note that thismay take a while, depending on how manycommands are in the memory and need tobe erased.5. When the Program/SPL Indicator c goesout, the remote has been reset to the factorysettings.4646