About MediaCenter 2200B storageLED state ConditionGreen, solid A valid AC source is connected to the power supply, and the powersupply is operational.Green (1 Hz blink) AC is present, but the power switch on the front panel is off or in acold redundant state due to low system power load.Green (2 Hz blink) Power supply firmware updating.Amber, blink Power supply is operational, but experiencing a warning event.Amber, solid AC power is lost or a power supply is shut down.CAUTION: If two power supplies are used, they must be of the same type and have thesame maximum output power.About MediaCenter 2200B storageThe MediaCenter 2200B provides 12 hot-swappable disk drives in a 2 x (4 +2) RAID set, and up to 48 TBof usable storage.Refer to the following table for supported RAID configurations.Table 6-1: MediaCenter 2200B RAID configurationsDrives RAID set Capacity per drive Storage capacity12 SAS 2 x (4+2) 6 TB 48 TB12 SAS 2 x (4+2) 4 TB 32 TB12 SAS 2 x (4+2) 2 TB 16 TBNOTE: No other disk drive configurations are supported.In SystemManager, use the “One-Click” function to create the file system and RAID set, and initialize thefile system. Follow the instructions in “Using One-Click Functions” in the SystemManager User Guide.Refer to the following image to identify the numbering of drives.Figure 6-11: MediaCenter 2200B drive numberingFor additional storage, you can connect the MediaCenter to the MediaStore 7200 via SAS.Related informationAbout the file system configuration for MediaCenter 2200B with MediaStore 7200 on page 219147 Spectrum System 8.4 Installation Guide