Adding and replacing system board components 9-11Replacing the system batteryFollow these steps to replace the battery:1. Place the blade of a small, flat-blade screwdriver under the edge of theretaining clip.2. Turn the screwdriver one quarter turn, raising the clip while pressing down onthe old battery to remove it.3. Carefully raise the retaining clip, and insert the new battery with the + symbolfacing out.4. Insert a new 3V lithium battery (CR2032) into the socket and press it downuntil the securing clip clicks and locks the battery in if you replace the systembattery, you need to reset the system date and time in Setup.INote: Before replacing the lithium battery review thelithium battery notice on page xii.Important:Make sure you insert the battery with thepositive side on top. A plus (+) sign indicatesthe positive side.
