BIOS Setup configuration 6-11Ultra DMA (Direct Memory Access)Ultra DMA provides a faster data transfer rate between the IDE devices and yoursystem than the conventional DMA mode. You can enable it by selecting the Autooption or disable it by selecting disable.IDE Burst ModeThis setting determines the acceleration of data transfer for IDE devices.IDE Data Port Post WriteThis setting determine the data transfer in the manner of "post write" featureIDE HDD Block ModeThis setting determines the automatic detection of the optimal number of blockRead/writes per sector that the hard drive could support.Video SetupSelect this menu item to modify the video settings.Init Display FirstUse this setting to specify which video subsystem to initialize first.System Shared Memory SizeUse this setting to select whether 4MB, 8MB, 16MB, 32MB or 64MB of systemmemory is to be used by video.PS/2 Mouse Detect FunctionUse this setting to determine whether or not the power-on self test will check to seeif a mouse is attached to the mouse connector.PCI slot Specifies a video card in a PCI slotOnboard Specifies the video subsystem on the system board
