60 IBM Desktop System HMMFactory-Installed Modem CardNOTE: The factory-installed modem is a 56.6 Kbpsmodem with a cable of microphone-in andspeaker-out from system board.001 - START• In Windows XP or Windows 2000 Device Manager,ensure that the modem is not configured with aconflicting COM port and IRQ setting.• Ensure that the communication software isconfigured with the correct COM and IRQ settings(same COM port and IRQ as the modem).• Ensure that all communication parameters (baudrate, data, stop and parity bits) are properlyconfigured and are identical on both sides.• Connect the phone line to the LINE port of themodem card.• Power off the system unit.NOTE: Check the outside phone line by connecting aworking telephone to the telephone wall jack.Listen for a dial tone to ensure that the phoneline is good.002 -• Power on the system unit.• Run the Diagnostics program from the servicepartition.• Select All Tests, then execute Modem test.003 - DOES THE MODEM PASS THE TEST? (YES,READ AHEAD. NO, GO TO STEP 004.)• Power off the system unit.• Remove all adapter cards.• Connect a hard disk drive with pre-loadedWindows XP, Windows 2000, or the otheroperating system.• Power on the system unit.• Perform the following steps under Windows XP,Windows 2000.NOTE: If an operating system other than MicrosoftWindows XP or Windows 2000 is installed, the
