IBM H SERIES RS/6000 User Manual

Also see for H SERIES RS/6000: Installation and service guide Installation and service guide

Testing the SetupThe following is a sample procedure to assure your setup is working.These tests include communicating with the server operating system. Be sure thenecessary serial port(s) is configured. If you need assistance, refer to “Serial PortConfiguration” on page B-4.The server should be powered off as a result of the “Service Processor SetupChecklist” on page B-1.Call-In:1. Go to your remote terminal and call-in to your server. Your server answers andoffers you the Service Processor Main Menu after requesting your privilegedaccess password.2. Select item 2, System Power Control.3. Select item 4, Power-On System.Answer y when asked if you wish to continue powering on the system.4. After the system firmware and operating system have initialized the server, thelogin prompt appears at your remote terminal if you set up Seamless ModemTransfer (refer to page C-6 for more information). This may take severalminutes. When this occurs, you have successfully called the Service Processor.5. Type logout to disconnect from the operating system. The message No Carrierdisplays on your remote terminal.6. Call your server again. The operating system answers and offers you the loginprompt. If these tests are successful, call-in is working.7. Login and command your server to shutdown and power off. (The AIX commandshutdown -F will do this.)8. The message No Carrier displays on your remote terminal.B-2 RS/6000 Enterprise Server Model H Series User's Guide