IBM H SERIES RS/6000 User Manual

Also see for H SERIES RS/6000: Installation and service guide Installation and service guide

Sample File modem_f.cfg## COMPONENT_NAME: (ESPSETUP) ENTRY SERVICE PROCESSOR SETUP F## FUNCTIONS: Modem configuration file for many recent Hayes\ compatible modems.# This example uses the AT&F reset command to choose the factory defaults.# This set up is preferred for modems with extended (&) commands. For early# vintage modems, setup Z or Zð is recommended. If your modem responds to# the extended (&) commands and to factory default choices (&Fn), setup file# Fð or F1 is recommended.## \ Trademark of Hayes Microcomputer Products, Inc.## (C) COPYRIGHT International Business Machines Corp. 1996# All Rights Reserved# Licensed Materials - Property of IBM## US Government Users Restricted Rights - Use, duplication or# disclosure restricted by GSA ADP Schedule Contract with IBM Corp.### If the modem has configuration switches, they should be set to the# factory default settings.ICDelay 1DefaultTO 1ðCallDelay 12ð# AT Attention Code , Inserts delay in dialing commands# &F Reset to default profile Qð Turn on responses# Eð Turn echo off Q1 Turn off responses# Vð Use numeric responses Sð=ð Automatic answer inhibit# +++ Escape to command mode Sð=2 Answer on second ring# Hð Hang-up Xð=ð Limit modem response codes# T = Tone mode. When used as T\r, it is a# no op to maintain program synchronization# when modem may/will echo the commands.## &C1 Detect CD &D2 Respond to DTR (often the default)## %N Call-Out phone number %P Paging phone number# %S Modem speed (available to users)## Following are common responses from a wide range of modems:# 16, 15, 12, 1ð, 5 and 1 are connection responses. Add others as required.# 7=busy; 6=no dial tone; 4=error; 3=no carrier; 2=ring; ð=OK## PROGRAMMING NOTE: No blanks between double quote marks (").condout: send "AT&FQðT\r" # Reset to factory defaults.ignore "ð\r" or "OK\r\n" timeout 2 # Ignore modem response.send "ATEðT\r" # Initialize modem: Echo OFF,expect "ð\r" or "OK\r\n" timeout 2 # Enable responses (Numeric),send "ATQðVðXðT\r" # Limit response codes.expect "ð\r" timeout 2 # Confirm commands successful.send "ATSð=ð\r" # Set AutoAnswer OFFexpect "ð\r" timeout 2 # Confirm command successful.send "AT&C1&D2\r" # Detect carrier and DTR.expect "ð\r" timeout 2 # Confirm command successful.doneconnect: send "ATDT%N\r" # Tone dialing command.# %N from Call Home setup.# Expect a connection response.expect "16\r" or "15\r" or "14\r" or "12\r" or "1ð\r" or "5\r" or "1\r" busy "7\r"timeout 6ðAppendix C. Modem Configurations C-19