v ServeRAID firmware is stored in ROM on the ServeRAID adapter.v SAS/SATA firmware is stored in ROM on the SAS/SATA controller on thesystem board.Configuring UEFI compatible devicesUse this information to configure UEFI compatible devices.UEFI compatible expansion cards can be configured through the Setup utility. Toconfigure a UEFI compatible expansion card, complete the following steps:Note: Before configuring a UEFI compatible device, it is recommended to updatethe firmware for your server. See “Updating the firmware” on page 111 forinformation on how to update the firmware for your server.1. Run the Setup utility (see “Using the Setup utility” on page 115).2. Select System Settings → Network or Storage depending on the type of youradapters.Note: Select System Settings → Adapters and UEFI drivers for UEFI 2.0 (andprior) compliant adapters and drivers installed in the server.3. Select Please refresh this page first and press Enter.4. Select the device driver that you want to configure and press Enter.5. When you have finished changing settings, press Esc to exit from the program;select Save to save the settings that you have changed.Configuring the serverThe following configuration programs come with the server:v Setup utilityThe UEFI Setup Utility program is part of the basic input/output systemfirmware. To change the startup-device sequence, set the date and time, and setpasswords. For information about using this program, see “Using the Setuputility” on page 115.v Boot Manager programThe Boot Manager program is part of the server firmware. Use it to override thestartup sequence that is set in the Setup utility and temporarily assign a deviceto be first in the startup sequence. For more information about using thisprogram, see “Using the Boot Manager program” on page 122.v IBM ServerGuide Setup and Installation CDThe ServerGuide program provides software-setup tools and installation toolsthat are designed for the server. Use this CD during the installation of the serverto configure basic hardware features, such as an integrated SAS/SATA controllerwith RAID capabilities, and to simplify the installation of your operating system.For information about using this CD, see “Using the ServerGuide Setup andInstallation CD” on page 114.v Integrated Management ModuleUse the integrated management module II (IMM2) for configuration, to updatethe firmware and sensor data record/field replaceable unit (SDR/FRU) data, andto remotely manage a network. For information about using the IMM, see“Using the integrated management module II” on page 123 and the IntegratedManagement Module User's Guide at http://www.ibm.com/systems/support/supportsite.wss/docdisplay?lndocid=MIGR-5079770&brandind=5000008.112 System x3300 M4 Type 7382: Installation and Service Guide
