IBM System x3300 M4 Installation And Service Manual

Also see for System x3300 M4: Product guide

Contents

IBM System x3300 M4 Installation And Service Manual Manual pdf 388 page image

Note: The positioning of the remote battery depends on the type of theremote batteries that you install.b. Connect the other end of the battery cable to the battery cable connectoron the battery.c. Lower and press down on the retention clip until it snaps in place to holdthe battery firmly in place.If you have other devices to install or remove, do so now. Otherwise, go to“Completing the installation” on page 104.Removing an optional ServeRAID adapter memory moduleTo remove an optional ServeRAID adapter memory module, complete thefollowing steps:1. Read the safety information that begins in Safety and “Installation guidelines”on page 36.2. Turn off the server (see “Turning off the server” on page 24) and all attachedperipheral devices.3. Disconnect all power cords; then, disconnect all external cables from the server.4. Carefully turn the server on its side so that it is lying flat, with the cover facingup.Attention: Do not allow the server to fall over.5. Unlock and remove the left-side cover (see “Removing the left-side cover” onpage 39)6. See the documentation that comes with the adapter for any cabling instructionsand information about jumper or switch settings. (It might be easier for you toroute cables before you install the adapter.)7. Remove the adapter (see “Removing an adapter” on page 358)8. Grasp the memory module and lift to remove it from the connector on theServeRAID adapter.370 System x3300 M4 Type 7382: Installation and Service Guide