v You have kept the preinstalled air deflector in place unless directed to remove itin this publication or by IBM Service. See “Removing the microprocessor 2 airbaffle” on page 175 for the location of the air deflector in the server.Working inside the server with the power onAttention: Static electricity that is released to internal server components whenthe server is powered-on might cause the server to halt, which might result in theloss of data. To avoid this potential problem, always use an electrostatic-dischargewrist strap or other grounding system when you work inside the server with thepower on.You might have to have the server turned on while the cover is off, to look at lightpath diagnostics LEDs or replace hot swap components. Follow these guidelineswhen you work inside a server that is turned on:v Avoid wearing loose-fitting clothing on your forearms. Button long-sleeved shirtsbefore working inside the server; do not wear cuff links while you are workinginside the server.v Do not allow your necktie or scarf to hang inside the server.v Remove jewelry, such as bracelets, necklaces, rings, and loose-fitting wristwatches.v Remove items from your shirt pocket, such as pens and pencils, that could fallinto the server as you lean over it.v Avoid dropping any metallic objects, such as paper clips, hairpins, and screws,into the server.Handling static-sensitive devicesAttention: Static electricity can damage the server and other electronic devices.To avoid damage, keep static-sensitive devices in their static-protective packagesuntil you are ready to install them.To reduce the possibility of damage from electrostatic discharge, observe thefollowing precautions:v Limit your movement. Movement can cause static electricity to build up aroundyou.v The use of a grounding system is recommended. For example, wear anelectrostatic-discharge wrist strap, if one is available. Always use anelectrostatic-discharge wrist strap or other grounding system when working insidethe server with the power on.v Handle the device carefully, holding it by its edges or its frame.v Do not touch solder joints, pins, or exposed circuitry.v Do not leave the device where others can handle and damage it.v While the device is still in its static-protective package, touch it to an unpaintedmetal part on the outside of the server for at least 2 seconds. This drains staticelectricity from the package and from your body.v Remove the device from its package and install it directly into the server withoutsetting down the device. If it is necessary to set down the device, put it back intoits static-protective package. Do not place the device on the server cover or on ametal surface.v Take additional care when handling devices during cold weather. Heating reducesindoor humidity and increases static electricity.Chapter 5. Removing and replacing server components 169
