Setup utility menu choicesThe following choices are on the Setup utility main menu for the UEFI. Dependingon the version of the firmware, some menu choices might differ slightly from thesedescriptions.v System InformationSelect this choice to view information about the server. When you make changesthrough other choices in the Setup utility, some of those changes are reflected inthe system information; you cannot change settings directly in the systeminformation. This choice is on the full Setup utility menu only.– System SummarySelect this choice to view configuration information, including the ID, speed,and cache size of the microprocessors, machine type and model of the server,the serial number, the system UUID, and the amount of installed memory.When you make configuration changes through other options in the Setuputility, the changes are reflected in the system summary; you cannot changesettings directly in the system summary.– Product DataSelect this choice to view the system-board identifier, the revision level orissue date of the firmware, the integrated management module anddiagnostics code, and the version and date.This choice is on the full Setup utility menu only.v System SettingsSelect this choice to view or change the server component settings.– ProcessorsSelect this choice to view or change the processor settings.– MemorySelect this choice to view or change the memory settings.– Devices and I/O PortsSelect this choice to view or change assignments for devices and input/output(I/O) ports. You can configure the serial ports, configure remote consoleredirection, enable or disable integrated Ethernet controllers, the SAS/SATAcontroller, SATA optical drive channels, PCI slots, and video controller. If youdisable a device, it cannot be configured, and the operating system will not beable to detect it (this is equivalent to disconnecting the device).– PowerSelect this choice to view or change power capping to control consumption,processors, and performance states.– Operating ModesSelect this choice to view or change the operating profile (performance andpower utilization).– Legacy SupportSelect this choice to view or set legacy support.- Force Legacy Video on BootSelect this choice to force INT video support, if the operating system doesnot support UEFI video output standards.- Rehook INT 19hSelect this choice to enable or disable devices from taking control of theboot process. The default is Disable.- Legacy Thunk Support260 IBM System x3550 M3 Types 4254 and 7944: Problem Determination and Service Guide
