interface (when you attempt to start the remote presence feature) indicating that thehardware key is required to use the remote presence feature.The virtual media key has an LED. When this LED is lit and green, it indicates thatthe key is installed and functioning correctly. When the LED is not lit, it indicatesthat the key might not be installed correctly.The remote presence feature provides the following functions:v Remotely viewing video with graphics resolutions up to 1600 x 1200 at 75 Hz,regardless of the system statev Remotely accessing the server, using the keyboard and mouse from a remoteclientv Mapping the CD or DVD drive, diskette drive, and USB flash drive on a remoteclient, and mapping ISO and diskette image files as virtual drives that areavailable for use by the serverv Uploading a diskette image to the IMM memory and mapping it to the server as avirtual driveThe blue-screen capture feature captures the video display contents before the IMMrestarts the server when the IMM detects an operating-system hang condition. Asystem administrator can use the blue-screen capture to assist in determining thecause of the hang condition.Enabling the remote presence featureTo enable the remote presence feature, complete the following steps:1. Install the virtual media key into the dedicated slot on the system board (see“System-board optional device connectors” on page 22).2. Turn on the server.Note: Approximately 20 to 40 seconds after the server is connected to power,the power-control button becomes active.Obtaining the IP address for the IMMTo access the Web interface, you need the IP address for IMM. You can obtain theIMM IP address through the Setup utility. The server comes with a default IPaddress for the IMM of 192.168.70.125. To locate the IP address, complete thefollowing steps:1. Turn on the server.Note: Approximately 20 to 40 seconds after the server is connected to power,the power-control button becomes active.2. When the prompt Setup is displayed, press F1. (This prompt is displayedon the screen for only a few seconds. You must press F1 quickly.) If you haveset both a power-on password and an administrator password, you must typethe administrator password to access the full Setup utility menu.3. From the Setup utility main menu, select System Settings.4. On the next screen, select Integrated Management Module.5. On the next screen, select Network Configuration.6. Find the IP address and write it down.7. Exit from the Setup utility.Chapter 6. Configuration information and instructions 267
