Setup utility menu choicesUse the Setup utility main menu to view and configure server configuration dataand settings.The following choices are on the Setup utility main menu for the UEFI. Dependingon the version of the firmware, some menu choices might differ slightly from thesedescriptions.v System InformationSelect this choice to view information about the server. When you make changesthrough other choices in the Setup utility, some of those changes are reflected inthe system information; you cannot change settings directly in the systeminformation. This choice is on the full Setup utility menu only.– System SummarySelect this choice to view configuration information, including the ID, speed,and cache size of the microprocessors, machine type and model of the server,the serial number, the system UUID, and the amount of installed memory.When you make configuration changes through other options in the Setuputility, the changes are reflected in the system summary; you cannot changesettings directly in the system summary.– Product DataSelect this choice to view the system-board identifier, the revision level orissue date of the firmware, the integrated management module anddiagnostics code, and the version and date.This choice is on the full Setup utility menu only.v System SettingsSelect this choice to view or change the server component settings.– Adapters and UEFI DriversSelect this choice to view information about the UEFI 1.10 and UEFI 2.0compliant adapters and drivers installed in the server.– ProcessorsSelect this choice to view or change the processor settings.– MemorySelect this choice to view or change the memory settings.– Devices and I/O PortsSelect this choice to view or change assignments for devices andinput/output (I/O) ports. You can configure the serial ports, configure remoteconsole redirection, enable or disable integrated Ethernet controllers, theSAS/SATA controllers, SATA optical drive channels, PCI slots, and videocontroller. If you disable a device, it cannot be configured, and the operatingsystem will not be able to detect it (this is equivalent to disconnecting thedevice).– PowerSelect this choice to view or change power capping to control consumption,processors, and performance states.– Operating ModesSelect this choice to view or change the operating profile (performance andpower utilization).– Legacy SupportSelect this choice to view or set legacy support.- Force Legacy Video on BootChapter 2. Configuration information and instructions 49
