v Enable Unattended Start Mode (1=Yes, 0=No)When enabled, ’Unattended Start Mode’ allows the system to recover from the loss of ac power.If the system was powered-on when the ac loss occurred, the system reboots when power is restored. Ifthe system was powered-off when the ac loss occurred, the system remains off when power is restored.You can access this service aid directly from the AIX command line, by typing:/usr/lpp/diagnostics/bin/uspchrp -bConfigure Remote Maintenance PolicyThe Remote Maintenance Policy includes modem configurations and phone numbers to use for remotemaintenance support.Use this service aid to display and change the following settings for the Remote Maintenance Policy.Note: Because of system capability, some of the following settings might not be displayed by this serviceaid.v Configuration File for Modem on serial port 1 (S1)Configuration File for Modem on serial port 2 (S2).Enter the name of a modem configuration file to load on either S1 or S2. The modem configuration filesare located in the directory /usr/share/modems. If a modem file is already loaded, it is indicated byModem file currently loaded.v Modem file currently loaded on S1Modem file currently loaded on S2This is the name of the file that is currently loaded on serial port 1 or serial port 2.Note: These settings are only shown when a modem file is loaded for a serial port.v Call In Authorized on S1 (on/off)Call In Authorized on S2 (on/off)Call In allows the Service Processor to receive a call from a remote terminal.v Call Out Authorized on S1 (on/off)Call Out Authorized on S2 (on/off)Call Out allows the Service Processor to place calls for maintenance.v S1 Line SpeedS2 Line SpeedA list of line speeds is available by using List on the screen.v Service Center Phone NumberThis is the number of the service center computer. The service center usually includes a computer thattakes calls from systems with call-out capability. This computer is referred to as ″the catcher.″ Thecatcher expects messages in a specific format to which the Service Processor conforms. For moreinformation about the format and catcher computers, refer to the README file in the AIX/usr/samples/syscatch directory. Contact the service provider for the correct telephone number to enterhere.v Customer Administration Center Phone NumberThis is the number of the System Administration Center computer (catcher) that receives problem callsfrom systems. Contact the system administrator for the correct telephone number to enter here.v Digital Pager Phone Number In Event of EmergencyThis is the number for a pager carried by someone who responds to problem calls from your system.v Customer Voice Phone Number98 pSeries 610 Model 6C3 and Model 6E3 User’s Guide