Step 15This step loads the standalone diagnostics.1. If you are running one or more logical partitions, reboot the partition.Note: Standalone diagnostics may be run with a CD-ROM or from a NIM server. If run from CD-ROM,the CD-ROM drive must be made available to the partition upon which you want to runstandalone diagnostics. After this is done, go to step 2. If running from NIM, the NIM servermust be set up to allow a diagnostic boot from that partition (both NIM server and client partitionmust have network adapters).2. Insert the diagnostic CD into the CD-ROM drive.3. When the keyboard POST indicator displays, press the numeric 5 key on the keyboard to indicate thatdiagnostics are to be loaded.4. Type the requested passwords.5. Follow the instructions to select a console.Did the Diagnostics Operating Instructions display without any obvious display problem?NO Go to “Step 7” on page 133.YES Go to “Step 9” on page 133.Step 16The diagnostics did not detect a hardware problem. If you still have a problem, contact your serviceorganization.136 pSeries 610 Model 6C3 and Model 6E3 User’s Guide
