Appendix D. Service Processor Setup and TestFor your convenience, an example of a basic service processor setup checklist is included here. Yoursetup may include more or fewer of the available features, so you can adjust this checklist for your ownapplication so that it is helpful to you.Service Processor Setup Checklist1. Unplug the power cord from the server.2. Attach a local terminal for this setup procedure.3. Plug in the system and power on the local terminal.Attention: Make sure that system power remains off.4. Start the service processor menus. See Chapter 4, “Using the Service Processor”, on page 27.5. Set the system name. See “Privileged User Menus” on page 29.6. Enable surveillance. See 34.7. Configure Call-In/Call-Out. See “Call-In/Call-Out Setup Menu” on page 46.8. Exit the service processor menus.9. Unplug the power cord from the system.10. Attach modems (if needed). See “Accessing the Service Processor Menus Remotely” on page 28.11. Plug in the system.Attention: Make sure that the system power remains off.12. Test both of the following:v Call-In, see “Testing Call-In” on page 150v Call-Out, see “Testing Call-Out” on page 150Your service processor is now ready for use.149