Serial Port Selection Menu1. Serial Port 1 Call-Out:Currently DisabledNOT supported in LPAR mode2. Serial Port 2 Call-Out:Currently DisabledNOT supported in LPAR mode3. Serial Port 1 Call-In:Currently Disabled4. Serial Port 2 Call-In:Currently Disabled98. Return to Previous Menu0>Call-in and ring indicate power-on cannot be enabled at the same time. If ring-indicate power-on is alreadyenabled and you try to enable call-in, a message prompts you for confirmation. Refer to the messagedisplayed on the screen.Serial Port Speed Setup MenuThis menu allows you to set serial port speed to enhance terminal performance or to accommodatemodem capabilities.Serial Port Speed Setup Menu1. Serial Port 1 Speed:Currently 96002. Serial Port 2 Speed:Currently 960098. Return to Previous Menu0>A serial port speed of 9600 baud or higher is recommended. The following are valid serial port speeds:50 600 480075 1200 7200110 1800 9600134 2000 19200150 2400 38000300 3600 57600115200Telephone Number Setup MenuNote: These menus are available, however, the function of calling out to report a system failure isnormally handled by the Service Focal Point application running on the HMC.Use this menu to set or change the telephone numbers for reporting a system failure.48 pSeries 610 Model 6C3 and Model 6E3 User’s Guide