Remote Supervisor IISlimLine adapter support bracketRemote Supervisor IISlimLine adapter retainer clipRemote Supervisor IISlimLine adapter6. Carefully grasp the Remote Supervisor Adapter II SlimLine by its top edge orupper corners, and align it with the Remote Supervisor Adapter II SlimLineguide and the connector on the system board.Attention: Incomplete insertion might cause damage to the system board orthe adapter.7. Press the Remote Supervisor Adapter II SlimLine firmly into the connector andunder the retention clip on the Remote Supervisor Adapter II SlimLine supportbracket.8. Close the rear adapter retention bracket.If you have other optional devices to install or remove, do so now. Otherwise, go to“Completing the installation” on page 46.Installing a memory moduleThe following notes describe the types of dual inline memory modules (DIMMs) thatyour server supports and other information that you must consider when you installDIMMs:v The server supports up to twelve 667 MHz, 1.8 V, 240-pin, PC2-5300double-data-rate (DDR) II, fully buffered synchronous dynamic random-accessmemory (SDRAM) with error correcting code (ECC) DIMMs. These DIMMs mustbe compatible with the latest 5300 SDRAM Fully Buffered DIMM (FBD)specification. For a list of supported optional devices for the server, seehttp://www.ibm.com/servers/eserver/serverproven/compat/us/.v At least one pair of DIMMs must be installed for the server to operate.Chapter 2. Installing optional devices 33