Establish a Serial over LAN (SOL) connection to manage servers from a remotelocation. You can remotely view and change the BIOS settings, restart the server,identify the server, and perform other management functions. Any standard Telnetclient application can access the SOL connection.Enabling and configuring SOL using the OSA SMBridge managementutility programTo enable and configure the server for SOL by using the OSA SMBridgemanagement utility program, you must update and configure the BIOS; update andconfigure the baseboard management controller (BMC) firmware; update andconfigure the Ethernet controller firmware; and enable the operating system for anSOL connection.BIOS update and configurationComplete the following steps to update and configure the BIOS code to enableSOL:1. Update the BIOS code:a. Download the latest version of the BIOS code from http://www.ibm.com/systems/support/.b. Update the BIOS code, following the instructions that come with the updatefile that you downloaded.2. Update the BMC firmware:a. Download the latest version of the BMC firmware from http://www.ibm.com/systems/support/.b. Update the BMC firmware, following the instructions that come with theupdate file that you downloaded.3. Configure the BIOS settings:a. Restart the server and press F1 when are prompted to start theConfiguration/Setup Utility program.b. Select Devices and I/O Ports; then, make sure that the values are set asfollows:v Serial Port A: Auto-configurev Serial Port B: Auto-configurec. Select Remote Console Redirection; then, make sure that the values areset as follows:v Remote Console COM Port: COM 2v Remote Console Baud Rate: 19200 or higherv Remote Console Connection Type: VT100v Remote Console Connect: Directv Remote Console Flow Control: Hardwarev Remote Console Active After Boot: Enabledd. Press Esc twice to exit the Remote Console Redirection and Devices andI/O Ports sections of the Configuration/Setup Utility program.e. Select Advanced Setup; then, select Baseboard Management Controller(BMC) Settings.f. Set BMC Serial Port Access Mode to Dedicated.g. Press Esc twice to exit the Baseboard Management Controller (BMC)Settings and Advanced Setup sections of the Configuration/Setup Utilityprogram.58 IBM System x3500 Type 7977: User’s Guide