IBM xSeries 200 Hardware Maintenance Manual

Also see for xSeries 200: Hardware Maintenance Manual Hardware Maintenance Manual

Contents

6. Disconnect the cable of the button kit from the systemboard.7. Place a screwdriver against the bottom release latch ofthe button kit and gently press upward and slide thelatch through the aperture.8. Gently pinch together the upper release latches andslide the latches through the aperture and remove thebutton kit.Guide assembly / speakerBefore you begin:v Read “Safety information” on page 125.v Review the information in “Before you begin” on page44.To remove the speaker, do the following:1. Power-off the server, if it is on.2. Unplug the server.3. Remove the cover (see “Removing the side cover” onpage 46).4. Remove the front bezel (see “Removing the bezel” onpage 48).5. Remove the support bracket (see “Removing thesupport bracket assembly” on page 49).6. Remove all adapter cards.7. Unplug the speaker from the system board.Chapter 6. FRU information (service only) 93