Table 4. NetWare driver messages for the Ethernetcontroller (continued)Message DescriptionAFT is not supportedon this version ofNetWare™.Explanation: The NetWare on your serveris not a version supported by AFT. Action:Load and bind AFT only on supportedversions of NetWare (currently version4.11 and above).Failed to allocateresources tags.Explanation: An unknown error hasoccurred when trying to allocate neededresources for the AFT module. Action:Check server configuration. If the problempersists, contact your network supplier.Please unload allLAN drivers beforeunloading AFT.NLM.Explanation: An attempt was made tounload the AFT.NLM module beforeunloading the adapter driver. Action:Unload the adapter driver before unloadingthe AFT module.NDIS 4.0 (Windows NT) drivermessagesThis section contains the error messages for the NDIS 4.0drivers. The explanation and recommended action areincluded with each message.Table 5. NDIS (Windows NT or Windows 2000) drivermessages for the Ethernet controllerErrorcode(hex) Description0x00 Explanation: The driver could not register thespecified interrupt. Action: Using theConfiguration/Setup Utility program, make sure that aPCI interrupt is assigned to your Ethernet card, andthat Ethernet is enabled.0x01 Explanation: One of the PCI cards did not get therequired resources. Action: Using theConfiguration/Setup Utility program, make sure that aPCI interrupt is assigned to your Ethernet card, andthat Ethernet is enabled.0x02 Explanation: Bad node address (multicast address).Action: Make sure the locally administered addressis valid, if one is specified. The address can not be amulticast address.0x03 Explanation: Failed self-test. Action: Make sure acable is attached to the Ethernet connector. If theproblem persists, call for service.28 Hardware Maintenance Manual: xSeries 200
