Table 5. NDIS (Windows NT or Windows 2000) drivermessages for the Ethernet controller (continued)Errorcode(hex) Description0x0D Explanation: Could not allocate enough memory fortransmit queues. Action:1. From the Windows NT desktop, select Start →Control Panel → Networks → Adapters.2. Select your IBM Ethernet adapter from the list.3. Select Properties → Advanced.4. Lower the resource values that apply to thetransmit queue.0x0E Explanation: Could not allocate enough memory forreceive queue. Action:1. From the Windows NT desktop, select Start→Control Panel →Networks →Adapters.2. Select your IBM Ethernet adapter from the list.3. Select Properties →Advanced.4. Lower the resource values that apply to thereceive queue.0x0F Explanation: Could not allocate enough memory forother structures. Action:1. From the Windows NT desktop, select Start →Control Panel → Networks → Adapters.2. Select your IBM Ethernet adapter from the list.3. Select Properties →Advanced.4. Lower the value for the resource named in themessage.0x10 Explanation: Did not find any Ethernet controllers.Action: Using the Configuration/Setup Utilityprogram, make sure that Ethernet is enabled.0x11 Explanation: Multiple Ethernet controllers found, butnone matched the required ID. Action: Using theConfiguration/Setup Utility program, make sure thatEthernet is enabled.0x13 Explanation: Did not find any Ethernet controllersthat matched the required subven/subdev. Action:Using the Configuration/Setup Utility program, makesure that Ethernet is enabled.0x16 Explanation: Single adapter found, but multipleinstances tried to load. Action: Using theConfiguration/Setup Utility program, make sure thatEthernet is enabled, and that the slot containing theIBM xSeries 200 10/100 Ethernet Adapter or the IBM10/100 Etherjet PCI adapter is enabled.0x17 Explanation: Slot parameter not specified in theregistry. Action: Remove the adapter driver andreinstall it. If the problem persists, call for service.Chapter 3. Diagnostics 29
