ICON Health & Fitness Weider 9000 User Manual

Contents

1326. Wrap the Low Cable (33) around a 90mm Pulley(24). Attach the Pulley and a Cable Trap (26) tothe second hole from the bottom of the two PulleyPlates (28) with an M10 x 45mm Bolt (57) and anM10 Nylon Locknut (49).28. Attach the Backrest (13) to the Centre Upright (5)with two M6 x 63mm Bolts (56) and two M6Washers (59).Before using the weight rack, pull each cable afew times to be sure that the cables movesmoothly over the pulleys. If one of the cablesdoes not move smoothly, find and correct theproblem. IMPORTANT: If the cables are notproperly installed, they may be damagedwhen heavy weight is used. See the CABLEDIAGRAMS on page 20 for proper cable rout-ing. If there is any slack in the cables, theywill need to be tightened; see TROU-BLESHOOTING AND MAINTENANCE on page21.27. Attach the end of the Low Cable (33) inside thehole in the Rear Upright (6) with an M10 x 65mmBolt (54), two M10 Washers (52) and an M10Nylon Locknut (49).1222. Attach the High Cable (31) to the M10 x 19mmBolt (not shown) in the bracket on the WeightCarriage (10) with an M10 Nylon Locknut (49).24. Wrap the Low Cable (33) around a 90mm Pulley(24). Attach the Pulley to the bottom of theDouble “U”-Bracket (29) with an M10 x 45mmBolt (57) and an M10 Nylon Locknut (49).25. Wrap the Low Cable (33) under a 90mm Pulley(24). Attach the Pulley to the bracket on the RearUpright (6) with an M10 x 45mm Bolt (57) and anM10 Nylon Locknut (49).23. Locate the Low Cable (33). Route the eyelet endof the Cable through the hole in the Foot Plate (9)and through the Centre Upright (5).Wrap the Low Cable (33) under a 90mm Pulley(24). Attach the Pulley inside of the CentreUpright (5) with an M10 x 65mm Bolt (54), twoM10 Washers (52), two 15mm x 13mm Spacers(39), and an M10 Nylon Locknut (49).22 262857492624332754526493328135 56595631491023242949573325332457649Bracket2433243952549Bracket3952495

/ 14

Related manuals for ICON Health & Fitness WEEMBE39220