ATTACHING WEIGHTS TO THE WEIGHT CARRIAGETo use the Weight Carriage (10), slide the desiredamount of weight (not included) onto each side of theweight tube on the Weight Carriage. Secure theweight with the two Weight Pins (37).To use Olympic weights, press two Adapter Bushings(44) into the ends of each Weight Adapter (23). Slidea Weight Adapter onto each side of the weight tubeon the Weight Carriage (10).173766231023WeightTube6537WARNING: Do not place more than68 kg (150 lbs.) on the Weight Carriage (10).Always place the same amount of weight oneach side of the Weight Carriage.ATTACHING WEIGHTS TO THE LEG LEVERTo use the Leg Lever (66), slide the desired amountof weight (not included) onto the Weight Tube (65)and secure it with the Weight Pin (37).To use Olympic weights, slide the Weight Adapter(23) onto the Weight Tube (65).WARNING: Do not place more than68 kg (150 lbs.) on the Weight Tube (65).87. Slide the Carriage Stop (19) onto the RearUpright (6). Make sure that the Carriage Stop isoriented so the Carriage Stop Bushing (20)and the indicated hole are in the positionsshown. Attach the Carriage Stop to the hole nearthe bottom of the Rear Upright with an M8 x70mm Bolt (58) and an M8 Nylon Locknut (48).Press two 25mm Round Inner Caps (45) into thetube on the Weight Carriage (10). Insert an M10 x19mm Bolt (61) into the bracket on the WeightCarriage. Slide the Weight Carriage onto the RearUpright (6). Be sure the bracket is on the sideshown.9. Attach the Top Frame (8) to the Crossbar (7) withtwo M10 x 68mm Bolts (46), two M10 Washers(52), and two M10 Nylon Locknuts (49).Attach the Top Frame (8) to the Centre Upright(5) with two M10 x 68mm Bolts (46), two M10Washers (52) and two M10 Nylon Locknuts (49).Do not tighten the M10 Nylon Locknuts (49)yet.10. Attach the Top Frame (8) to the Rear Upright (6)with three M10 x 68mm Bolts (46), two SupportPlates (14), and three M10 Nylon Locknuts (49).Tighten the M10 Nylon Locknuts (49) used insteps 2–10.8. Press three 50mm Square Inner Caps (43) intothe indicated ends of the Top Frame (8).7 4545106119Hole65843987524910814146464949 4954646843434820852313073ATTACHING THE LAT BAR TO THE HIGH PULLEYSTATION OR THE LOW PULLEY STATIONTo use the high or low pulley station, attach the LatBar (73) to the High Cable (31) or the Low Cable (notshown) using a Cable Clip (30). The Row Bar (notshown) can be attached in the same manner.WARNING: Always remove the LatBar (73) when performing an exercise that doesnot require the use of the Lat Bar.221 222STORING WEIGHTSTo store weights, slide them onto the Storage Tubes(22) on the Right and Left Bases (1, 2).