3: INSTALLATION AND WIRING« FC4A MICRO SMART USER ’S MANUAL » 3-7Mounting on DIN Rail1. Fasten the DIN rail to a panel using screws firmly.2. Pull out the clamp from each MicroSmart module,and put the groove of the module on the DIN rail.Press the modules towards the DIN rail and push inthe clamps as shown on the right.3. Use BNL6 end clips on both sides of the MicroSmartmodules to prevent moving sideways.Removing from DIN Rail1. Insert a flat screwdriver into the slot in the clamp.2. Pull out the clamps from the modules.3. Turn the MicroSmart modules bottom out.Direct Mounting on Panel SurfaceMicroSmart modules can also be mounted on a panelsurface inside a console. When mounting a slim typeCPU module, digital I/O module, analog I/O module,HMI base module, or communication module, useoptional direct mounting strip FC4A-PSP1P asdescribed below.Installing the Direct Mounting Strip1. Remove the clamp from the module by pushing theclamp inward.2. Insert the direct mounting strip into the slot where theclamp has been removed (A). Further insert the directmounting strip until the hook enters into the recess inthe module (B).Caution • Install the MicroSmart modules according to instructions described in this user’s manual.Improper installation will result in falling, failure, or malfunction of the MicroSmart.• Mount the MicroSmart modules on a 35-mm-wide DIN rail or a panel surface.Applicable DIN rail: IDEC’s BAA1000PN10 or BAP1000PN10 (1000mm/39.4” long)Groove35-mm-wide DIN RailClamp35-mm-wide DIN RailClamp(A)(B)Direct Mounting StripFC4A-PSP1P
