6: ALLOCATION NUMBERS« FC4A MICRO SMART USER ’S MANUAL » 6-5Operand Allocation Numbers for END Refresh Type Analog I/O ModulesNote: Each analog I/O module uses 20 data registers. When analog modules are not connected, the corresponding dataregisters can be used as ordinary data registers.Operand Allocation Numbers for AS-Interface Master ModuleNote: AS-Interface master module uses internal relays and data registers shown above. When AS-Interface master moduleis not connected, these internal relays and data registers can be used as ordinary internal relays and data registers.Analog I/O Module Number Analog Input Channel 0 Analog Input Channel 1 Analog Output Reserved1 D760-D765 D766-D771 D772-D777 D778, D7792 D780-D785 D786-D791 D792-D797 D798, D7993 D800-D805 D806-D811 D812-D817 D818, D8194 D820-D825 D826-D831 D832-D837 D838, D8395 D840-D845 D846-D851 D852-D857 D858, D8596 D860-D865 D866-D871 D872-D877 D878, D8797 D880-D885 D886-D891 D892-D897 D898, D899MicroSmart CPU Module AS-Interface Master Module EEPROMOperand Allocation No. AS-Interface ObjectAS-Interface Internal RelaysM1300-M1617 Digital input (IDI)M1620-M1937 Digital output (ODI)M1940-M1997 Status informationAS-Interface Data RegistersD1700-D1731 Analog inputD1732-D1763 Analog outputD1764-D1767 List of active slaves (LAS)D1768-D1771 List of detected slaves (LDS)D1772-D1775 List of peripheral fault slaves (LPF)D1776-D1779 List of projected slaves (LPS)D1780-D1811 Configuration data image A (CDI)D1812-D1843 Configuration data image B (CDI)D1844-D1875 Permanent configuration data A (PCD)D1876-D1907 Permanent configuration data B (PCD)D1908-D1923 Parameter image (PI)D1924-D1939 Permanent parameter (PP)D1940 Slave 0 ID1 codeD1941-D1945 For ASI command descriptionD1946-D1999 — Reserved —
