IDS X64 User Manual

Also see for X64: Training manual User manual Installer manual Installer manual Manual

IDS X64 User Manual Manual pdf 11 page image

Section: 4IDS X64 LCD Keypad User Manual 700-411-01C Issued August 2010 114. Disarming the Control Panel4.1 How to Disarm with a User Code[#] [USER CODE]1. Enter the premises through a designated entry route. Entering via any other route will cause analarm.2. As soon as the Entry/Exit zone is violated, the entry delay will begin. The keypad buzzer willsound for the duration of the entry period.3. Press the [#] key and enter a valid [USER CODE]. If an error beep occurs, press the [#] keyand re-enter the user code.4. Once the system disarms, the ARM LED will turn off and the keypad buzzer will stop sounding.5. If no valid user code has been entered prior to the expiry of the entry delay period an alarmcondition will be registered.6. If the entry period is too short, have your installer change the entry delay period.NOTE:If a strobe (or flashing light) has been installed and an alarm condition is registered, the strobe willcontinue flashing after the siren has stopped sounding. Entering a valid [USER CODE] will cancel thestrobe.4.2 How to Disarm using a Key-Switch or Remote1. Activate the remote or key-switch. (The blue button on the remote, unless otherwiseprogrammed).2. The system will disarm and the remote indicator (if installed) will turn off. If the siren toot ondisarm option is enabled, the siren will provide a double toot when the panel is disarmed.5. Bypassing Zones The term BYPASS is used to describe a zone that has been deactivated; i.e. violation of abypassed zone is ignored and will not cause an alarm condition. Once the system is armed, it is not possible to bypass zones. All bypassed zones will be automatically cancelled each time the panel is disarmed and must bere-bypassed before the next arming.5.1 How to Bypass / Un-bypass a ZoneHold down [9] until the beep,then enter [USER CODE] [*] [ZONE NUMBER] [*] [*] [#]1. Ensure the panel is not armed.2. To enter bypass mode, hold down [9] until the beep.3. The LCD display reads „User Code + *‟.4. Enter the [USER CODE] followed by the [*] key.