IDS X64 User Manual

Also see for X64: Training manual User manual Installer manual Installer manual Manual

IDS X64 User Manual Manual pdf 8 page image

Section: 3IDS X64 LCD Keypad User Manual 700-411-01C Issues August 201083. Arming the Control Panel3.1 Away Arming3.1.1 How to Away Arm[#] [USER CODE] (Leave via Entry/Exit Zone)1. Ensure that the LCD display reads „Ready to Arm‟ alongside the partition number being armed. Ifnot, check that all protected doors and windows are closed and that all movement has ceased inareas covered by motion detectors. If necessary, bypass any required zones and close the frontdoor.2. Press the [#] key.3. Enter a valid [USER CODE]. If an incorrect code is entered, the keypad buzzer will beep threetimes. In the event of an error, press the [#] key and re-enter the code.4. The ARM LED will come on and the keypad buzzer will sound for the duration of the exit delay.The LCD display will read „Exit Delay‟ alongside the partition number that is being armed. Anybypassed zones will be displayed on the LCD display as solid text. Any violated zones will bedisplayed on the LCD display as flashing text. To scroll through zones which have beenbypassed or violated use the [PANIC] and [MED] keys.5. Leave only via a designated exit route. The panel will away arm at the end of the exit delay, if anyenter/exit zone is violated, e.g. the front door.6. Once the panel has armed, the LCD display will read „Armed‟ alongside the partition that hasbeen armed.3.1.2 Quick Away Arm - Shortcut Key(Hold down the [1] key until the keypad buzzer sounds)If this function is enabled, it is possible to AWAY arm by simply holding down the [1] key. The LCDdisplay will read „Exit Delay‟ alongside the partition number being armed. The keypad buzzer sounds andthe arming process begins.NOTE:If the partition is already STAY armed, this key will initialize AWAY arming. It is therefore possible tochange directly from STAY armed to AWAY armed.3.2 Stay ArmingStay arming allows the user to monitor selected perimeter zones and bypass interior zones. The user canremain on the premises with access to designated areas during the STAY ARM cycle. Any zone that maybe violated accidentally should be programmed as a buzz zone. When violated, a buzz zone will causethe keypad buzzer to sound for 30 seconds before sounding the siren. Entering a valid user code beforethe siren sounds, prevents an alarm condition from being registered and will silence the keypad buzzerand prevent the siren from sounding.