KINO-CVR-D25502/N26002P a g e 45S te p 4: Open the SO-DIMM socket arms. Gently pull the arms of the SO-DIMM socketout and push the rear of the SO-DIMM down. (See Figure 4-1)S te p 5: Secure the SO-DIMM. Release the arms on the SO-DIMM socket. They clip intoplace and secure the SO-DIMM in the socket.S te p 0:4.4 J u m p e r S e ttin g sNOTE:A jumper is a metal bridge used to close anelectrical circuit. It consists of two or three metalpins and a small metal clip (often protected by aplastic cover) that slides over the pins to connectthem. To CLOSE/SHORT a jumper meansconnecting the pins of the jumper with the plasticclip and to OPEN a jumper means removing theplastic clip from a jumper. Figure 4-2: Jumper LocationsBefore the KINO-CVR-D25502/N26002 is installed in the system, the jumpers must be setin accordance with the desired configuration. The jumpers on theKINO-CVR-D25502/N26002 are listed in Table 4-1.Description Type LabelAT/ATX mode select 2-pin header JP2Table 4-1: Jumpers4.4.1 AT/ATX Mo d e S e le c t J u m p e rJ u m p e r La b e l: JP2J u m p e r Typ e : 2-pin headerJ u m p e r S e ttin g s : See Table 4-2J u m p e r Lo c a tio n : See Figure 4-3
