KINO-CVR-D25502/N26002P a g e 50To connect a digital display device to the KINO-CVR-D25502/N26002, please follow theinstructions below.S te p 1: Locate the HDMI connector. The location of the HDMI connector is shown inanother chapter.S te p 2: Align the HDMI connector. Align the male HDMI connector on the digitaldisplay device cable with the female HDMI connector on the external peripheralinterface.S te p 3: Insert the HDMI connector. Once the connectors are properly aligned with themale connector, insert the male connector from the digital display device into thefemale connector on the KINO-CVR-D25502/N26002.S te p 4: Secure the connector. Secure the HDMI connector from the digital displaydevice to the external interface by tightening the two retention screws on eitherside of the connector. S te p 0:4.6.3 LAN Co n n e c tio nThere are two external RJ-45 LAN connectors. The RJ-45 connector enables connectionto an external network. To connect a LAN cable with an RJ-45 connector, please followthe instructions below.S te p 1: Locate the RJ-45 connectors. The location of the LAN connectors is shown inChapter 3.S te p 2: Align the connectors. Align the RJ-45 connector on the LAN cable with one ofthe RJ-45 connectors on the KINO-CVR-D25502/N26002. See Figure 4-7.
