n Setting TAG channelsFor more efficient scanning, add the desired channels asTAG channels or clear the TAG for unwanted channels.Channels that are not tagged will be skipped during scan-ning. TAG channels can be assigned to each channel groupindependently.q While pushing and holding [H/L], push [DIAL] severaltimes to select the desired channel group.w Select the desired channel to be set as a TAG channel.e Push [F], then push [5• TAG ] to set the displayed chan-nel as a TAG channel.• “TAG” appears in the display.r To cancel the TAG channel setting, repeat step e.• “TAG” disappears.✓ Clearing (or setting) all tagged channelsWhile pushing and holding [H/L], push [5• TAG ] for 3 sec.(until a long beep changes to 2 short beeps) to clear all TAGchannels setting in the selected channel group.• Repeat above procedure to set all TAG channels.n Starting a scanSet scan type (Priority or Normal scan) and scan resumetimer in advance using Set mode. (p. 107)q While pushing and holding [H/L], push [DIAL] severaltimes to select the channel group, if desired.w Set TAG channels as described at left.e Make sure the squelch is closed to start a scan.r Push [F], then push [4• SCN ] to start Priority or Normalscan.• “PRI-SCAN 16” or “NORMAL SCAN” appears in the display.• When a signal is detected, scan pauses until the signal disap-pears or resumes after pausing 5 sec. according to Set modesetting. (Channel 16 is still monitored during Priority scan.)• Rotate [SELECTOR] or push [Y]/[Z] on the microphone tocheck the scanning TAG channels, to change the scanning di-rection or resume the scan manually.• A beep tones sounds and “16” blinks when a signal is receivedon Channel 16 during Priority scan.t To stop the scan, push [CLR] or repeat step r.165 SCAN OPERATIONNew2001