266SCAN OPERATION6red.se-ro-erst To start the scan, push [MODE•SCAN].• Scan pauses when a signal is received.• Rotate [DIAL] to change the scanning direction, or resumesmanually.• Push [MODE•SCAN] again to stop the scan.NOTE: Instead of the steps e to t operations, whilepushing and holding [MODE•SCAN], rotate [DIAL] to se-lect the desired scan type. In this case, scan starts whenreleasing [MODE•SCAN].About the scanning steps: The selected tuning step ineach frequency band (in VFO mode) is used during scan.FMSKIPPFMSKIPP• During full/band scan • During programmed scanon4”
