Icom IC-R8500 Instruction Manual

Also see for iC- r8500: Instruction manual Service manual Service manual Service manual addendum Service manual

3610COMMAND LIST• ‘OK’ message from IC-R8500 to PC • ‘NG’ message from IC-R8500 to PC• Memory channel contents set & write (1A 00)The above data packet is an example of program-ming the following into memory channel 123 of banknumber 19:• Frequency: 1,234,567,890 Hz• Mode: FM• Tuning step: 199.5 kHz (programmable step)• Attenuator: 10 dB• Scan select: specified• Scan skip: specified• Memory name: IC-R8500Scan skip and select channelsFE FE E0 4A FB FDPreamble codePC’s addressIC-R8500’s addressOK codeEnd of message codeFE FE 4A E0 1A 00 1 9 0 1 2 3 9 0 7 8 5 6 3 4 1 2 0 5 0 1 1 3 9 5 1 9 1 0 0 3 4 9 4 3 2 0 5 2 3 8 3 5 3 0 3 0 FDMemory nameTuning stepMode (Sc)FrequencyCH no.Bank SCNATTPreamble codeIC-R8500’s addressPC’s addressCommand numberSub command(IC-R8500’s command)10 Hz1 Hz1 kHz100 Hz100 kHz10 kHz10 MHz1 MHz1 GHz100 MHzEnd of message codeASCII codeBCD code area(only needed when ‘13’is selected)I C - R 8 5 0 0FE FE E0 4A FA FDPreamble codePC’s addressIC-R8500’s addressNG codeEnd of message codeCommentnumber Scan select Scan skip00 OFF OFF01 OFF Specified02 Specified OFF03 Specified Specified• Clearing the specified channel data(Memory channel contents set & write)• Special bank number and channels (bn)FE FE 4A E0 1A 00 19 0 1 2 3 FF FDPreamble codePC’s addressIC-R8500’s addressCommand numberEnd of message codeBlank dataMemory channelnumberIC-R8500’s commandBank numberSpecial bank Bank numberFREE 20AUTO 21SKIP 22PROG 23PRIO 24Remarks• For programmedscan, channel num-bers are as follows:0P1=00, 0P2=01,1P1=02, 1P2=03,etc., up to 9P1=18and 9P2=19.• There is only onechannel in the prior-ity bank.• Gain and level data (gd; BCD data)AF GAINSQUELCHMax.counterclockwise0000Max.clockwise0255IF SHIFTAPF controlMax.counterclockwise0000Max.clockwise0255center0128