Icom IC-V80 Instruction Manual

Also see for IC-V80: Instruction manual Quick guide Service manual addendum Step-by-Step Programming Guide

19Previous view■ Subaudible tonesSome repeaters require subaudible tones to access.Subaudible tones are superimposed over your normalsignal, and must be set in advance.q Push [FUNC](M), and then push [SET](8) to enterthe Set mode.w Push [Y] or [Z] to select the repeater tone item (rt).e Rotate [VOL] to select the desired subaudible tonefrequency.r Push [# ENT] to exit the Set mode.• Available subaudible tone frequencies (unit: Hz)67.069.371.974.477.079.782.585.488.591.594.897.4100.0103.5107.2110.9114.8118.8123.0127.3131.8136.5141.3146.2151.4156.7159.8162.2165.5167.9171.3173.8177.3179.9183.5186.2189.9192.8196.6199.5203.5206.5210.7218.1225.7229.1233.6241.8250.3254.1✔ CONVENIENT!Tone scan:If you don’t know the subaudible tone used for a repeater, thetone scan is convenient for detecting the tone frequency.➥ Push [FUNC](M), and then push [T.SCAN](3) tostart a tone scan.• See page 32 for details of the Tone Scan function.D 1750 Hz TONETo access some European repeaters, the transceivermust transmit a 1750 Hz tone burst.For only IC-V80E➥ Quickly push [PTT] once, then immediately holddown [PTT] again for 1 or 2 seconds.For other transceiversNOTE: First, set the DTMF TX key to “dmt.t” in the Setmode. (p. 34)➥While holding down [PTT], hold down either the [Y]or [Z] for 1 or 2 seconds.■ DTCS encoder (Only TX)The DTCS encoder superimposes the selected DTCScode over your transmitted signal.q Push [FUNC](M), and then push [SET](8) to enter the Setmode.w Set the DTCS code and polarity, in the same way youset the DTCS squelch. (p. 30)• You can set the DTCS transmit and receive polarity, butthe DTCS encoder affects only transmit.e Push [# ENT] to exit the Set mode.r Push [FUNC](M), and then push [TONE](1) severaltimes, until both “D ” and “ ” appear.• The DTCS encoder activated.(88.5 Hz is selected)• The “Repeater tone” item in the Set modePush , and then push several timesto turn ON the DTCS encoder.DTCS encoder (Only TX)5 REPEATER AND DUPLEX OPERATIONS