Icom IC-V80 Instruction Manual

Also see for IC-V80: Instruction manual Quick guide Service manual addendum Step-by-Step Programming Guide

21Previous view■ General descriptionThe transceiver has 207 memory channels, including6 scan edge memory channels (3 pairs), and 1 Callchannel. These channels can be individually pro-grammed with:• Operating frequency (p. 13)• Passband width (p. 13)• Duplex direction (+ or –) with frequency offset (p. 18)• Reversed Duplex function ON/OFF (p. 18)• Subaudible tone encoder (p. 19), tone squelch or DTCSsquelch ON/OFF (p. 31)• Subaudible tone frequency (p. 19), CTCSS tone frequen-cy or DTCS code with polarity (p. 30)• Skip setting (p. 28)• Tuning step (p. 13)• Output power (p. 15)• TX permission (p. 39)q Push [VFO/MR/CALL] several times to select the VFOmode.w Set the desired frequency.➥ If desired, set other data (e.g. frequency offset,duplex direction, tone squelch, and so on.).e Push [FUNC](M), and then push [VFO/MR/CALL].• “X” and the memory channel number blink.r Push [Y] or [Z] to select the memory channel to beprogrammed.• Select 1A/b, 2A,b or 3A/b to program a scan edge chan-nel. (p. 27)• Select the Call channel (“C”) to program the Call chan-nel.t Push [FUNC](M), and then hold down [VFO/MR/CALL]for 1 second to program.• 3 beeps sound.• The memory channel number automatically increases,when continuing to hold down [VFO/MR/CALL] after pro-gramming.NOTE: To cancel programming, push [VFO/MR/CALL]before doing step t.(VFO mode)Set the frequency.Push or to select channel 11.Push , and then push .Automatically returns to the VFO mode.Push , and then hold down for 1 second.[i.e.]: programming 145.440 MHz into memory channel 11.■ Programming memory/Call channelMEMORY/CALL OPERATION6