8411SCAN OPERATION11 Scan start/stopDD PreparationSet the scan resume condition (p. 89); program the scanedges (pgs. 85–87); program 2 or more memory channels(pgs. 74–76); set skip settings (p. 88), if desired.DD Scanning from the applicationqSelect VFO mode for programmed scan; or memory modefor memory/mode select scan with [V/M].• Select a memory channel which the desired operating mode isprogrammed.w Click [SCAN].e Select the desired scan type.• After the selection, the selected scan starts.*The above list indication is for instruction description only. In theactual application clearly shows the selectable items only.r To cancel the scan, click [SCAN] again then select “OFF.”DD Scanning with the RC-24qSelect VFO when programmed scan; or select memorymode when memory/select mode scan with [V/M].• Select a memory channel which the desired operating mode isprogrammed.wPush [SCAN•8] momentarily to start programmed or mem-ory scan; push [SCAN•8] for 0.5 sec. to start select modescan.• Decimal point, “.”, blinks during programmed scan; “M” indica-tor blinks during memory/select mode scan.e To cancel the scan, push [SCAN•8] momentarily.[SCAN•8]Selectable when VFO has beenselected.Selectable when memory modehas been selected.Click

supplied accessories

panel description

I Rear panel

I Microphones (HM-118N)

I Remote controller (RC-24; Optional for some versions)

I Unpacking

I Power supply connections

I Microphone and speaker connections

I Connecting a PC

I COM port conﬁrmation

I Preparation

I Squelch level adjustment (FM mode only)

I Audio level adjustment

I Setting a frequency

basic operation

I Tuning step selection

I Operating mode selection

I Your call sign setting

I Station/Repeater call sign setting

I FM mode operation

I When receiving a Digital call

I Short message function

I Monitor function

I General

I Accessing an FM repeater

I Repeater tone frequency setting

I Offset frequency setting

I Accessing a Digital repeater

I Precaution

I Internet access

I Data transferring

I Low-speed data communication

i general description

i call channel selection

main screen

memory channel screen

I Memory clearing

I Programming memory name

scan operation

I Scan start/stop

I Skip channel setting

i scan resume condition

priority watch

I Pocket beep operation

I Tone/Digital code/call sign squelch operation

other functions

I EMR mode operation

I Break-in communication

I S-meter squelch

troubleshooting

i fuse replacement

specifications and options

Icom ID-1 Instruction Manual

ID-1

explicit definitions

PANEL DESCRIPTION

Rear panel

Mcrophone

function display

Unpackng

installation and connections

power supply connections

DRIVER INSTALLATION

APPLICATION INSTALLATION

BASIC OPERATION

Squelch level adjustment (FM mode only)

VFO and memory mode

Tunng step selecton

tuning step selection

lock function

CALL SIGN SETTING

TRANSMIT AND RECEIVE— VOICE

when calling the desired station

Dgtal voce mode operaton

Montor functon

REPEATER OPERATION— VOICE

General

repeater tone frequency setting

offset frequency

DATA OPERATION

internet access

Low-speed data communcaton

general description

call channel selection

memory clearing

Memory name ndcaton

Scan types

Scan start/stop

skip channel setting

Set mode

pocket beep operation

standby beep

auto repeater

EMR mode operaton

S-meter squelch

CPU reset

fuse replacement

RC-24

MAIN UNIT

LOGIC-1 UNIT

transmitter circuits

PLL CIRCUITS

POWER SUPPLY CIRCUITS

PORT ALLOCATION

PREPARATION

PLL AND CODEC ADJUSTMENT

TRANSMITTER ADJUSTMENT

RECEIVER ADJUSTMENT

main unit

front unit