233REPEATER OPERATION3N Accessing a repeaterqSet the receive frequency (repeater output frequency).(pgs. 14, 15)wPush and hold [DUP](LOW) for 1 sec. to enter the duplexsetting condition.eRotate [DIAL] to select minus duplex or plus duplex.• “DUP–” or “DUP” appears to indicate the transmit frequency forminus shift or plus shift, respectively.• Push [DUP](LOW) again to return to the frequency indication.[DUP]“DUP–” or “DUP” appearsrPush and hold [TONE](M/CALL) for 1 sec. to enter thetone setting condition.t Rotate [DIAL] to turn ON the subaudible tone encoder, accord-ing to repeater requirements, then push [TONE](M/CALL).• “T” appears• 88.5 Hz is set as the default; refer to p. 25 for tone frequencysettings.• When the repeater requires a different tone system, see p. 26.[TONE]“T” appearsy Push and hold [PTT] to transmit.• The displayed frequency automatically changes to the transmitfrequency (repeater input frequency).• If “OFF” appears, confirm that the frequency offset (p. 27) is setcorrectly.u Release [PTT] to receive.While receiving While transmittingi Push [MONI] to check whether the other station’s transmitsignal can be received directly.o To return to simplex operation, push and hold [DUP](LOW)then rotate [DIAL], to clear the “DUP–” or “DUP” indicator.• Push [DUP](LOW) again to return to frequency indication.!0 To turn OFF the subaudible tone encoder, push and hold[TONE](M/CALL) then rotate [DIAL] until no tone indicator(OFF) appears.• Push [TONE](M/CALL) again to return to frequency indication.
